Differences in core principles
Low temperature evaporator (vacuum low-temperature evaporation) relies on vacuum negative pressure to reduce the boiling point of the solution, and the evaporation temperature is generally controlled at 35-60 ℃; The heat source often uses hot water, thermal oil, and electric heating, without the need for a steam compressor. Boil and vaporize the waste liquid at low temperature in a low-pressure environment, and condense the steam to obtain distilled water.
The evaporation temperature of MVR evaporator (mechanical vapor recompression) is usually around 80-105 ℃; Relying on a steam compressor to increase the pressure and temperature of the secondary steam, and reusing it as a heating source for recycling, is a heat recovery evaporation process that belongs to the high-temperature evaporation route.
Key Comparison
Evaporation temperature&scaling tendency: Low temperature evaporator has a low temperature, which makes it difficult for heat sensitive materials, easily crystallizable, and volatile waste liquids to denature, resulting in a lower scaling rate; MVR temperature is relatively high, and salt and organic matter are more likely to precipitate and scale, requiring higher pre-treatment requirements.
Energy consumption characteristics of low-temperature evaporator: without compressor, heat consumption is the main factor, and the water consumption per ton is generally higher than that of conventional MVR; The advantage lies in the miniaturization of equipment and low investment threshold. MVR evaporator: It relies on the compressor to recover latent heat, and has significant energy consumption advantages in large-scale processing. The larger the processing capacity, the lower the unit evaporation cost.
Suitable for waste liquid scenarios ✅ Low temperature evaporators are more suitable for: low water volume high salt waste liquids, emulsions, cutting fluids, electroplating waste liquids, hazardous waste reduction, laboratory/production line scattered waste liquids, and heat sensitive wastewater; Most of the models are small and easy to install. ✅ MVR evaporators are more suitable for medium to large water volume, saline wastewater, chemical wastewater, and saltwater concentration, pursuing continuous large-scale stable concentration.
Equipment investment, land occupation, and operation of low-temperature evaporators: simple structure, whole machine installation, low investment, and small land occupation; No high-speed compressor, few fault points, simple maintenance. MVR evaporator: including steam compressor, complex self-control system, high initial investment; Compressors are high-speed equipment that require regular maintenance and lubricant replacement, which places higher demands on operators.
Continuous low-temperature evaporation is often used for intermittent batch processing, which is suitable for factories with unstable waste liquid production and large production fluctuations; MVR focuses on continuous feeding and discharging, suitable for stable and continuous production of wastewater.
Both water quality and products can be separated into condensate (distilled water) and concentrate; The control of volatile organic compounds in low-temperature evaporation distilled water depends on the collection of exhaust gas; Under high temperature conditions in MVR, some volatile components are more easily carried out with secondary steam, which requires stricter requirements for pre oil and VOC removal.
Summary of Selection in One Sentence
Small water volume, complex waste liquid composition, limited budget, only focusing on hazardous waste reduction: prioritize low-temperature evaporators
Stable water volume and high daily evaporation capacity, if you want to reduce operating energy consumption in the long term, prioritize MVR evaporators